Home |
Search |
Today's Posts |
|
#1
![]() |
|||
|
|||
![]()
In article ,
Al Klein wrote: On 18 Mar 2006 11:56:04 GMT, (Scott Ehrlich) wrote: What else could I be missing? Has the radio become defective? It was purchased new, out of the box. The squelch output (DC that gets higher as the detected noise gets higher) feeds 2 points - the computer, so it knows whether to scan or stop and an audio gate that cuts off the audio when there's no signal. It sounds as if either the audio gate is allowing signal through regardless of the state of the squelch output, or the squelch output isn't getting to the audio gate. How you can check that out without a schematic (RS schematics of recent products are rare) is the tough question. Is there any other reasonable way to get around it? Thanks. Scott |
#2
![]() |
|||
|
|||
![]() |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
No more white noise | General | |||
RACAL RA-17C12 with DSP / digital readout | Shortwave | |||
Icom 746pro Testimonial | Shortwave | |||
Transformer for longwire antennas to reduce noise problem? | Shortwave | |||
Transformer for longwire antennas to reduce noise problem? | Shortwave |