Home |
Search |
Today's Posts |
#6
![]() |
|||
|
|||
![]() On Jan 22, 5:41*pm, wrote: On Jan 22, 9:37 am, wrote: You bring up an interesting point Ace - I did get a continuous signal here and couldn't decide whether it was long path and short path at the same time, or whether I was actually getting the moon bounce? Food for thought! John Plimmer, Montagu, Western Cape Province, South Africa Terry wrote John, if you are into building your own stuff you may wish to consider building a variation of the PA0RDT min-whip that Dallas Lankford came up with.. http://www.kongsfjord.no/dl/Antennas...0Complementary %20Push-Pull%20Output%20Active%20Whip%20Antennas%20II.pdf I live very close, within three miles, *to two *MW stations that drive many active antennas, including the original PA0RDT mini-whip into overload. Dallas's version is bullet proof. Any IMD products are covered by the natural noise floor. Terry- Hide quoted text - Terry, Prof. Dallas is one of our greatest hobby experts but I think my RF Systems DX1 Pro MkII will outperform his designs. The DX1 is also bullet proof against close by stations, it has the highest IP3 point of any antenna on the market. As for the PAORDT mini-whip, it is a piece of junk that I should take off my listing = poor pickup and sucks up every bit of noise in the neighbourhood. As for DIY, if I pick up a soldering iron I will do myself serious damage and burn the house down = not an option for a 70 ear old dodo! John Plimmer, Montagu, Western Cape Province, South Africa South 33 d 47 m 32 s, East 20 d 07 m 32 s RX Icom IC-756 PRO III with MW mods Drake SW8 & ERGO software Sony 7600D, GE SRIII, Redsun RP2100 BW XCR 30, Sangean 803A. Antenna's RF Systems DX 1 Pro Mk II, Datong AD-270 Kiwa MW Loop, PAORDT Roelof mini-whip http://www.dxing.info/about/dxers/plimmer.dx |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
moon bounce | Policy | |||
moon bounce | CB | |||
moon bounce | Swap | |||
Moon Bounce | Shortwave |