On 1/3/11 09:31 , bpnjensen wrote:
Aiming to raise a new wire antenna here the next couple of weeks, and
I'd like to get some Flexweave for the run, probably 14 gauge will be
adequate for my purpose. I'd like to get it coated with either PVC or
the shrinktube material.

Does anyone have any experience with either of these coverings? Can
anyone say whether the material retains its flexibility, or if the
wire is stiffened by the covering? I'd surely like the flexibility to
remain, if at all possible.

Thanks,
Bruce



Anything you put over the wire will affect it's flexibility. And, the
larger the diameter the wire, the worse this effect will be pursuant to
the tensile properties of the covering material, and the coefficient of
friction at the interface with wires of the Flexweave. Shrink is also
less flexible, in itself, and is quite snug when finished, so
flexibility can be quite compromised.

This is why shrink is used as strain relief at connectors.

There are materials that may be applied in liquid form that dry to
form a very nice seal of flexible material over the Flexweave, but
these, too, will affect flexibility of the finished antenna wire.
Though, generally, not as much as hot or cold shrink.

The question is whether or not these effects will be sufficient to
make the wire difficult to handle.

Realistically...likely not. You won't be tying bow ties with it, and,
in fact, the covering will add additional support and strain relief to
the flexweave in heavy weather, but there will a reduction in overall
flexibilty.