LinkBack Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #17   Report Post  
Old July 4th 03, 12:17 PM
N8KDV
 
Posts: n/a
Default



Robert F Wieland wrote:

If I understand you correctly, you propose to put coax between the end of
your wire and the project box containing the balun (autotransformer). I
would recommend moving the box to the end of the wire, and using the run
of coax going back to the receiver to "come down" from the box to the
ground.


Yes. And it depends on how the transformer is wound/connected. The ones I use
here use a separate ground from the feedpoint. (So, what I'm using are two
ground rods, feedpoint, from the transformer, and at the shack from the
receiver.) The winding off the toroid from the wire itself is totally separate
from the winding that goes to the coax.

Now, it is possible to connect the grounds at the transformer (ala MLB) and
avoid the ground at the feedpoint. I've used/made them both ways, but I prefer
the two ground method.

This would, I admit, give you a problem of how to make the ground
connection to the coax shield at the antenna end;


I run the coax near the end into a Transi-trap... ground that, and after that
the only ground is from the receiver.

you could use a
grounding block, which requires your coax run to have connectors at this
point, or you need to do some "surgery" to the coax to take off the outer
covering without cutting the shield (for this, go to a sewing shop and
look at the tool called a "seam ripper", and you may see how to use it to
"uncover" coax shield).

This is a slightly funny antenna, the wire together with the exterior of
the coax shield, creates a grounded Inverted-L that has its feedpoint not
at the ground stake, but at the balun.

I've been playing with the idea of winding a coil with the coax at the
ground stake (back-of-envelope calculations say 200 uH) which makes this
antenna self-decoupling: at high frequencies, the high reactance
disconnects the "bottom" of the antenna from the ground, and it's a
bent dipole; at low frequencies, the low reactance makes it an Inverted-L.
One antenna for LW to 30MHz?

You asked for ideas...

--

R F Wieland Newark, DE 19711-5323 USA 39.68N 75.74W
Icom R75 Heathkit GR-81 Inverted-L in the attic
Reply to wieland at me dot udel dot edu


 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Parallel balun problem with wire loop loopfan Antenna 7 March 23rd 04 09:36 PM
Balun question... Fred Scanner 0 February 24th 04 01:57 PM
Adding a 2:1 balun to a multi-band dipole Larry Gauthier \(K8UT\) Antenna 4 February 5th 04 06:22 AM
Horizontal loop - balun or no balun ? Per Enocson Antenna 5 December 14th 03 01:28 AM
Balun Grounding Question ? Robert11 Antenna 6 November 23rd 03 09:39 PM


All times are GMT +1. The time now is 03:45 AM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 RadioBanter.
The comments are property of their posters.
 

About Us

"It's about Radio"

 

Copyright © 2017