Icom R8500 failure
 

Can anybody help me about an unexpected failure in an Icom R8500
receptor?
No more signal, no more audio output, no way to enter a new frequency
with "MW" button. The display flashes continuously.
Has anybody experienced such a phenomenon ?
Help needed since there is no Icom support in the place where I live.
Thank you.
AitKaci

Can you do a full reset?



"maitkaci" wrote in message
m...
Can anybody help me about an unexpected failure in an Icom R8500
receptor?
No more signal, no more audio output, no way to enter a new frequency
with "MW" button. The display flashes continuously.
Has anybody experienced such a phenomenon ?
Help needed since there is no Icom support in the place where I live.
Thank you.
AitKaci

AitKaci
Expensive Hobby:

it Might have taken a power hit & fried something ..
delicate & inside the set.
IS there a power problem in your area?
Was it hooked up to a Surge Protector?

E-mail ICom & see if there is a certified dealer nearby;
else check w a dealer such as Universal Radio & see what they think.
Are there internal batteries that may have failed?

The only thing I can think of is
Unplug it,
then power it on & let it sit for 24 hrs;
shut it off, hook it up & turn it on & hope for the best

- Good Luck

Dan


In article ,
(maitkaci) writes:


Can anybody help me about an unexpected failure in an Icom R8500
receptor?
No more signal, no more audio output, no way to enter a new frequency
with "MW" button. The display flashes continuously.
Has anybody experienced such a phenomenon ?
Help needed since there is no Icom support in the place where I live.
Thank you.
AitKaci

ubject: Icom R8500 failure
From: (maitkaci)
Date: 11/23/2003 1:00 AM Mountain Standard Time
Message-id:

Can anybody help me about an unexpected failure in an Icom R8500
receptor?
No more signal, no more audio output, no way to enter a new frequency
with "MW" button. The display flashes continuously.
Has anybody experienced such a phenomenon ?
Help needed since there is no Icom support in the place where I live.
Thank you.
AitKaci

I recently experienced the same problem with my R8500 after accidentally
shutting off the power to the set with the switch on the surge protector. I
turned the unit back on with the main power switch, the display flashed for
about five minutes, and then the receiver appeared to reset itself. My R8500
is now working fine and I am able to enter frequencies manually with no
problems.

If there was a power failure in your area recently, I would suggest trying to
reset your R8500 by using the above procedure. The flashing display, loss of
audio output, and temporary loss of keyboard function seem to be common to the
R8500 after an interruption of AC power. Good luck.

73,
David