Question for Albert P.
 

Hi Al-

I was wondering what you used to connect your RX-340 & SE-3 with?
What I'm inquiring here is do you use any type of special BNC cable
(Audioquest, Monster, Rat Shack, etc...). Also, do you by chance know
what the impedance rating is of the SE-3 IF input? I believe the
RX340's IF output is 50 ohms, but not 100% sure. Just trying to tweak
the audio a bit through proper cable matching.

Thanks
Dave

On 7 Apr 2004 05:22:22 -0700, (davehs67) wrote:

Hi Al-

I was wondering what you used to connect your RX-340 & SE-3 with?
What I'm inquiring here is do you use any type of special BNC cable
(Audioquest, Monster, Rat Shack, etc...). Also, do you by chance know
what the impedance rating is of the SE-3 IF input? I believe the
RX340's IF output is 50 ohms, but not 100% sure. Just trying to tweak
the audio a bit through proper cable matching.

Thanks
Dave

Hi, Dave.

I don't use an SE-3 with my 340s.

Other than avoiding the occasional need to diddle the IF gain and/or
programmable AGC in order to deal with SAM-unlock/relock on rapidly
deep-fading strong signals, do you find much benefit from substituting
the SE-3's SAM?


Good listening,
Al
=================================================
Location: 42N39, 71W09 (Near Boston, MA)
HF Antennas: 65ft TFD, 45ft T2FD, 28ft vertical, 65ft doublet
HF Receivers: Ten-Tec RX340, RX320, Harris R2368, Cubic R3030A
Decoders: Code300-32, Universal M-8000, PK-232MBX/DSP
=================================================

Albert P. Belle Isle wrote in message . ..

Hi, Dave.

I don't use an SE-3 with my 340s.

Other than avoiding the occasional need to diddle the IF gain and/or
programmable AGC in order to deal with SAM-unlock/relock on rapidly
deep-fading strong signals, do you find much benefit from substituting
the SE-3's SAM?


Good listening,
Al

Hi Al-

My bad, I thought that was how you had your 340 setup (w/the SE-3).
About your question, I prefer the sound of the SE-3 (warmer?), plus I
like the way you can set & forget the sync and it will hold it's lock
no-matter-what. I actually run the audio (after the SE-3) through a
couple of optical compressors & then into a tube eq which helps take
some of the bite out of the static.

cheers
Dave