About Us

September 27th 04, 12:57 AM

"Richard Clark" wrote in message
...
On 26 Sep 2004 14:55:49 -0700, (TheGnome)
wrote:

I
managed to get 75 feet of #26 magnet wire on a perpendicular roof to
my window of my dorm room, and two runs of 15' speaker wire as a
counterpoise in my room. I'm getting a really bad noise problem

Hi OM,

Use coax out 25-30 of those 75 feet. At the far end, put your
counterpoise there and thus move your input to a position remote from
that same noise (presumably in your room). At that same far end, add
a 1:1 BalUn or W2DU style otherwise known as a Current BalUn rather
than a Voltage BalUn (the distinction in this regard is important).
This will keep noise from coupling to the outside of your coax and
funneling into the feedpoint (as long as your receiver has good
shielding). It is called "choking." This will help with radiative,
local noise. You can add a second BalUn on the antenna/counterpoise
side for Z transformation, if you choose.

If the noise is conductive, then it is coming in through your power
supply (AC is carrying trash). Good ground can help solve this,
unless you are in a room on a high floor. You can confirm conductive
noise by breaking all AC and ground paths and running on battery power
(if this is an option) or connecting your antenna to a battery powered
receiver. Another option (if no battery options are available) is to
get a long extension cord and try another outlet that you can identify
as being on a separate breaker (this may not be easy in a dorm
situation). With this, you may find a quiet AC branch that is not
shared with the noise generators.

73's
Richard Clark, KB7QHC

I agree with Richard.

The problem with outside antennas and noise often results from the
noise being carried common-mode on the outside of the cable
braid BACK to the antenna. Use a decoupling choke at the
antenna end of the coax. The 9:1 balun or transformer will
minimize losses due to high impedance swings at certain
frequencies--it won't do much for noise however.

Pete

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Inverted V Noise Problem	Warren Bowery	Antenna	9	November 29th 04 01:19 AM
Transformer for longwire antennas to reduce noise problem?	[email protected]	Antenna	8	September 29th 04 05:43 AM
s9 noise problem related to position of antenna tuner?	tedoboxer	Antenna	5	March 1st 04 02:02 PM
Poor quality low + High TV channels? How much dB in Preamp?	lbbs	Antenna	16	December 13th 03 03:01 PM
signal to noise ratio drops on connecting the antenna	Ashhar Farhan	Homebrew	6	September 22nd 03 10:54 PM

Menu

About Us