| Home |
| Search |
| Today's Posts |
|
#1
|
|||
|
|||
|
I was wondering if passing a coaxial cable used for antenna very close to
electronics like TV, stereo, etc. will cause some intereferance that could penetrate inside? I need to run the cable to balcony for my antenna and electronics are in my way. |
|
#2
|
|||
|
|||
|
depends on the shielding of the coax.
General rule is there shouldn't be any problem. "Michalkun" wrote in message .251... I was wondering if passing a coaxial cable used for antenna very close to electronics like TV, stereo, etc. will cause some intereferance that could penetrate inside? I need to run the cable to balcony for my antenna and electronics are in my way. |
|
#3
|
|||
|
|||
|
You'll only have a problem if you're running a lot of power and the
shielding is poor quality, or if there's current on the outside of the coax. Current on the outside can be reduced with a "current" or "choke" balun. Roy Lewallen, W7EL Michalkun wrote: I was wondering if passing a coaxial cable used for antenna very close to electronics like TV, stereo, etc. will cause some intereferance that could penetrate inside? I need to run the cable to balcony for my antenna and electronics are in my way. |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Indoor Wireless Cable TV Transmission | Antenna | |||
| Length of Coax Affecting Incident Power to Meter? | Antenna | |||
| Coax Cable vs Freqency | Antenna | |||
| Old coax | Antenna | |||
| 50 ohm or 75 ohm cable foe dipole? | Antenna | |||