Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
Old November 1st 03, 04:02 AM
Rod B
 
Posts: n/a
Default What band rubber duck is this? 2m / 440 ?

Wondering if anyone would care to take a guess as to what kind of
antenna
I have here. The only marking on it is "Motorola" near the bottom.
The antenna is 7 and 1/4 inches long and flares a bit near the bottom,
its BNC type and has a small round "ball" near the top. It RX's "OK"
on commercial UHF but rolls off near the ham bands of UHF which makes
me think its not UHF at all. Different antenna on same radio is like
night and day. Take a guess?

Thanks

http://f1.pg.photos.yahoo.com/ph/njc....src=ph&.view=
  #2   Report Post  
Old November 1st 03, 04:18 AM
AC6JA
 
Posts: n/a
Default

it might be an 800/900mhz antenna.
hard to tell as many look similar.
might need to put on an antenna analyzer.
  #3   Report Post  
Old November 1st 03, 04:53 PM
Ruut Bol
 
Posts: n/a
Default

I do have almost the same but not BNC which is used for 403-470 mHz...
Ruut
"AC6JA" schreef in bericht
...
it might be an 800/900mhz antenna.
hard to tell as many look similar.
might need to put on an antenna analyzer.



  #4   Report Post  
Old November 1st 03, 05:55 PM
Ed G.
 
Posts: n/a
Default



tough call. At first I thought 800MHz, but is too long for 800MHz, not
shaped right for 800MHz gain, and never saw an 800MHz with BNC connector,
so....

Its probably either a 1/4 wave UHF, or a loaded VHF..... kinda hard
to tell... depends on whats inside the "fat" part of the rubber covered
base.



Perhaps you could mount it on the output of a wattmeter with
appropriate adapter, and test a low powered VHF and then a UHF radio into
it and check the SWR.

Another idea..... take a known ham dual band HT with BNC connector,
check a constant level VHF and then a UHF signal strength with the HTs
antenna, then swap with the unknown antenna and compare again.....




Ed WB6SAT

  #5   Report Post  
Old November 2nd 03, 04:28 AM
**THE-RFI-EMI-GUY**
 
Posts: n/a
Default

I don't think Motorola ever made an 800 MHz antenna with a BNC, it is
likely a UHF model. Is there a color code anywhere?

Rod B wrote:

Wondering if anyone would care to take a guess as to what kind of
antenna
I have here. The only marking on it is "Motorola" near the bottom.
The antenna is 7 and 1/4 inches long and flares a bit near the bottom,
its BNC type and has a small round "ball" near the top. It RX's "OK"
on commercial UHF but rolls off near the ham bands of UHF which makes
me think its not UHF at all. Different antenna on same radio is like
night and day. Take a guess?

Thanks

http://f1.pg.photos.yahoo.com/ph/njc....src=ph&.view=




--
Joe Leikhim K4SAT


"Jazz is not dead. It just smells funny." -F.Z.



  #6   Report Post  
Old November 2nd 03, 02:52 PM
JOCK tec
 
Posts: n/a
Default

what color is the bottom of the BNC connector??? (usually BLACK)


Looks like a UHF antenna for the HT-90 or HT-440 radio by Motorolaâ„¢. I think
these are the only radios that used a BNC connector.


Also- Motorola never has used a BNC on a 800 MHz. radio.
Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
FA : GROVE Active Duck antenna Dan Conti Shortwave 5 December 23rd 04 07:26 PM
Breaker 19, This here's the Rubber Duck FREEBANDER_4_LIFE CB 7 December 23rd 04 07:09 AM
FA : GROVE Active Duck antenna Dan Conti Scanner 3 December 22nd 04 03:50 AM
Where did the name "Rubber Duck" come from Dr. Anton Squeegee General 1 October 22nd 03 07:12 PM


All times are GMT +1. The time now is 11:42 PM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 RadioBanter.
The comments are property of their posters.
 

About Us

"It's about Radio"

 

Copyright © 2017