| Home |
| Search |
| Today's Posts |
|
|
|
#1
September 5th 06, 04:50 PM
posted to rec.radio.swap
|
|||
|
|||
Needed: Kenwood PS-50 fan motor
Thought my PC fan bearings were going bad... then the squealing was happening w/ the PC off... (dopey me). Anyone have a fan motor (or assy) for a PS-50? It's a Mitsubishi MDN-7R3 Mine's from 1988, and has had constant use. I'd like to dismantle it and oil / replace the bearings, but I no longer have a motor case crimp tool. I sent a few emails to Kenwood over the past couple weeks w/ no success. I'd really like to be back on PSK-31. -KD6MHL |
|
#2
September 6th 06, 01:21 AM
posted to rec.radio.swap
|
|||
|
|||
|
Needed: Kenwood PS-50 fan motor
Mr. Chips wrote:
Thought my PC fan bearings were going bad... then the squealing was happening w/ the PC off... (dopey me). Anyone have a fan motor (or assy) for a PS-50? It's a Mitsubishi MDN-7R3 Mine's from 1988, and has had constant use. I'd like to dismantle it and oil / replace the bearings, but I no longer have a motor case crimp tool. I sent a few emails to Kenwood over the past couple weeks w/ no success. I'd really like to be back on PSK-31. -KD6MHL Any 12V dc fan of the same size will work! I would go for one that pushes a lot of air ( higher CFM ) to be on the safe side... Bob N9LVU |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| fs: Kenwood kpt50 repeater radio programmer | Antenna | |||
| Kenwood R-5000 (R5000) Receiver - Information and Resources | Shortwave | |||
| Kenwood programming cable needed | Swap | |||
| Kenwood TM-231A help needed | Homebrew | |||
Hybrid Mode
