| Home |
| Search |
| Today's Posts |
|
#3
December 29th 03, 11:55 AM
|
|||
|
|||
In article ,
Dick wrote: I burned out the 2-meter finals in my TM-741. You should be able to buy a new RF module at http://www.rfparts.com/module.html If you are handy with a soldering iron, it's not a difficult job. Just take your time. BTW, the symptoms were very little RF power out. It was just the driver feeding through the dead finals. Dick - W6CCD On 28 Dec 2003 20:04:23 -0800, (David) wrote: We have a repeater close buy our house and i didn't know it but i was talking on 2 meters with out an antenna but when i noticed it was too late i think i burned the finals out it talks but it kickes out and a loud hum comes through the speaker is it the module that is out or something in the hole radio please help me Dave Wx5atx I replaced a final module in a TM732 once and upon removing the bad module I found NO heat grease on the heat sink. It was dry as a bone. Dale, K9VUJ -- |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| fs: Kenwood kpt50 repeater radio programmer | Homebrew | |||
| fs: Kenwood kpt50 repeater radio programmer | Equipment | |||
| fs: Kenwood kpt50 repeater radio programmer | Swap | |||
| Kenwood R-5000 (R5000) Receiver - Information and Resources | Shortwave | |||
| fs: Kenwood kpt50 repeater radio programmer | Equipment | |||
Threaded Mode
