***** Roller Coil ******

La Pointe L-0201 406-1 (identical to a Johnson 229-201) 10 uH. used
good, $30

New! GE Ceramic end plates, part no. 7463338, for a GE roller coil. I
believe these fit the GE coil that was used in the BC-375. $10 pair

***** B&W Air Dux coils *****

These are NOS, 10" lengths, unless noted otherwise

#1208T 1.5" dia, 8TPI, #16 wire, slight tarnish $20
#1216T 1.5" dia, 16TPI, #20 wire, somewhat tarnished $20
#1006T 1.25" dia, 6TPI, #14 wire, somewhat tarnished $15

plus a NOS partial length

#1008T 1.25" dia, 8 TPI, #16 wire, 8" long -- $12

--- some other partial lengths

#2408T 3" dia, 8 TPI, #14 wire, 4" long shiny -- $15
#2410T 3" dia, 10 TPI, #14 wire, 2.5" slightly tarnished -- $10

#3030 2.5"" dia, 8 TPI, #14 wire, 4" tarnished -- $10
#3031 2.5"" dia, 10 TPI, #16 wire, 3" long somewhat tarnished
-- $10
#3031 2.5"" dia, 10 TPI, #16 wire, 1.75" long somewhat
tarnished -- $5

---a couple of Illumintronic Engineering parts

375 7367-P1 -- 1.5" dia.x 5.75" winding w/ indented turns, 14 TPI,
#17, 7" overall including plastic center support, un-used somewhat
tarnished $25

980-0121-000 -- 2.5" dia. x 7.5" winding w/ indented turns, 8 TPI,
#14, 9.5" overall including plastic center support, used somewhat
tarnished but, no turns soldered $30

A large RF choke -- #22 enameled wire space wound 24 TPI for 2.75 on a
1" diameter grooved fiberglass form 5" overall -- $5

Miller 62A024 series (.173-.272uH I think!?) coils, 1/4" diameter wound
with a 5 turn coil. Blue (carbonyl SF 40-300 MHz) core. 4
terminals, 2 currently unused. NOS. 2/$1

Toroidal Tank coil -- The core is fiberglass & resin encased. It is
currently wound with 20 turns of #12 wire. There are notches in the
form for up to 40 turns. It is a bit over 4 inches in diameter and
about 1-3/4" thick. This was made by Bob, W6YUY. See his article in
August 1985 Ham Radio magazine "Design a Toroidal Tank Circuit for you
Vacuum Tube Amplifier". $50




All of the above plus shipping, if necessary, naturally.

Contact: Marv WC6W 310 649 3111 (reasonable hours Pacific Time
please)





*