Nice. Best response I've seen on a modeling question since I started
watching this group.
tom
K0TAR
Richard Clark wrote:
Hi Jerry,
Well, I presume you've corresponded here enough to recognize the
answers to questions fit what the respondent chooses.
Open EZNEC;
Select the "Open" button that is at the top left of the application;
Select the W8JK.EZ design offered;
From the string of "" selections, choose "Plot Type";
then select "3 Dimensional" - "OK" (and respond "OK" again to prompt);
Finally select the "FF Plot" button at the bottom left.
snip
73's
Richard Clark, KB7QHC
|