Nice. Best response I've seen on a modeling question since I started
watching this group.

tom
K0TAR

Richard Clark wrote:


Hi Jerry,

Well, I presume you've corresponded here enough to recognize the
answers to questions fit what the respondent chooses.

Open EZNEC;
Select the "Open" button that is at the top left of the application;
Select the W8JK.EZ design offered;
From the string of "" selections, choose "Plot Type";
then select "3 Dimensional" - "OK" (and respond "OK" again to prompt);
Finally select the "FF Plot" button at the bottom left.

snip

73's
Richard Clark, KB7QHC