"MR NO SPAM" wrote in message
...
I forgot to mention one thing. I've torn apart many packs when I was
scrapping for cells in a severe shortage. I had several packs here. I took
a
fine pair of dikes and cut/peel the straps off just under them from the
battery. I reuse them to do other packs. THEY ARE SHARP... BE CAREFUL.
They'll get you like a razor or paper cut. In a pinch, I also use regular
wire as a strap. Small gauge, about 18 or higher. MNS
"MR NO SPAM" wrote in message
...
"Bill" wrote in message
...
"Ralph Mowery" wrote in message
...
"Bill" wrote in message
...
What do you think about just replacing the batteries inside with
new
Ni-Cads
from the store? Any problems just soldering them together, or
should
I
buy
"shaver" batteries with the terminals built in, though they are
much
more
money?
Most batteries are very difficult to solder to if they do not have
the
solder tabs built on. The material does not seem to take solder
very
well
and also you can over heat the battery. The solder tabs are usually
spot
welded on.
I've "roughed" up the ends of nicads a bit - scratching them with a
knife
or
sandpaper or whatever, then spot "soldered" or "tinned" them prior to
adding
any leads. I've had pretty good success doing that. Some cells do give
trouble not wanting to take solder, but most have done ok. IF you're
good
at
soldering, you should be able to do it with minimal heat to the battery.
I've rebuilt more packs than I can remember. My earlier problem was - in
experimenting - I used older cells with "some" life left. After a while
they
did die and had to be replaced, sooner than newer cells of course. But
then
I bought new cells and have had good luck with all packs. So, it isn't
impossible! MNS
Thanks guys. I do quite a bit of soldering but never tried doing batteries.
I couldn't imagine them being any harder than anything else, but I wasn't
sure. I suppose some people might skip the tinning process, but that is what
makes most jobs easier.
$100. plus tax sure scares me into trying a homebrew approach.
|