I have a Weller EC1002 soldering station. It isn't working anymore...

I don't think the problem is with the iron it self. the heater has
continuity.
How does the temp sensor work?
is there anywhere I can get a schematic of the innards?
anybody have any ideas?


I have a manual for it at work. Will try to find it for a copy for you.
However, I don't think there is a "schematic" per se, in it. Might help if
you clarified your symptoms on your u nit. I just had problems with one
of those units not one month ago. It was the pencil part, and not the
control unit in my case. Symptoms were low solder temperature.... unit
would barely melt solder unless I turned it up quite high. I replace the
heater unit but that didn't help. Only other thing in the handle part is
the temp sensor. I don't know how it works, but suspect it went bad.
Swapping in a new handle assembly (over $100.00) fixed it. I still want
to try to repair the handle assy when I get a chance.


Ed WB6SAT