On Mon, 18 Jul 2005 02:05:56 GMT, (Robert
Lay) wrote:

On Sun, 17 Jul 2005 19:54:10 -0400, "larry" wrote:

Greetings

I am looking for a schematic diagram of a zepp antenna, including the 1/4
matching line and and matchiing method of 50 ohm coax cable...

Are there any website which would show this?...

Larry ve3fxq



Dear Larry,

There's nothing to show - it's too simple for a picture. You just take
a 1/2 wavelength of horizontal antenna and you end-feed it from one
side of a piece of balanced line 1/4 wavelength long. You then link
couple that to the final tank coil and do your matching with the
swinging link and the tank circuit. No equations, no schematics or
pictures - just do it!


Bob, W9DMK, Dahlgren, VA

Perhaps, to do it justice, I should explain that my one and only
experience with a Zepp antenna was in a situation in which the 1/4
wave balanced line section was open wire feeders with about 6" spacing
and the transmitter used a pair of plate modulated, push pull 10's as
the final - link coupled, as I already mentioned. In those days no one
had a clue as to load impedances or conjugate matching. We had an RF
ammeter in the transmission line and we tuned everything for maximum
reading on that meter. Those were the days.

Bob, W9DMK, Dahlgren, VA
Replace "nobody" with my callsign for e-mail
w9dmkatcrosslinkdotnet
http://www.qsl.net/w9dmk
http://zaffora/f2o.org/W9DMK/W9dmk.html