you can use assitional softwarre or hardware on mpt1327 but in facts its not
needed so much as following converations especially on the on site trunk
nets is usually quite easy 4/5 freqs,the annoying ones are ones where
control ch has been set to change and rotate through the other channels
every few mins


but if on site all one does is then monitor the input,mobile freq.

as far as ican make out thee for example ob that ione is one xontrol and
one voice,so in fact all comms on one freq,as you can have single/dual
channel or multi channel mpt1327 and not always fully trunking between 3 o
more freqs.

others are set up so forr 99 per cent of day to day listeninin is on ay
456.6 the voice channel i havve on the above one,but then suddenly a seocnd
freq for voice is found because more than usual amount of activity is on the
net,then you suddenly find another freq in the trunk net.

so just type in the voice channels known of any tunk net and listen,if you
then want to use softwae and hardaware for some systems then there are some
who are really into that and know a lot more
regards,Paul
"JC" johncalias-newsgroupsATyahooD0TcoD0Tuk wrote in message
...
On Mon, 22 Aug 2005 19:53:04 GMT, "PromaBoss"
wrote:


453.77500 460.27500 FM THE MALL SHOPPING CENTRE MPT1237 TRUNK CONTROL
CHANNEL ROMFORD ESSEX

What type of scanner will pick up the MPT1237 trunked transmissions??


--

Regards

John [Essex, UK]
Remove the obvious spamtrap to reply