Run the Ladder line to near the entrance of the PVC, and then use a
BALUN, to COAX, for the run down your PVC, BUT remember: PVC stands
for: PIPE VERY CROWDED! Jim NN7K

Dan Richardson wrote:
On Sun, 22 Jan 2006 08:29:29 -0700, jimbo wrote:


I am getting close to pulling some cable through a 1 1/4 inch PVC
conduit that runs about 20 feet from the third floor attic to the
basement. The contractor claims the conduit is a "straight shot" with
no bends. I have three LMR240 cables with PL259 connectors on each
end. And I would also like to pull a 450 ohm length of ladder line.
(Measures about 1 inch.) And I would like to pull at least two 16 gage
insulated control wires.

Any advice would be appreciated.


Forget the ladder line! It will be a disaster.





email: k6mheatarrldotnet
http://www.k6mhe.com/