On Fri, 15 May 2015 20:02:34 -0400, Jerry Stuckle wrote:

No one else understands what he proposes, either.

It's seems quite clear to me and I can see what he means. Hole alignment
is solved by clamping the two end sheets (front and rear panel) together
when drilling the holes for the threaded studding. Using domed nuts on
the outside would finish it off nicely.

A two part case could easily be formed as two shallow 'U' shaped pieces
(top and bottom). These could be held in place by attaching fixing
brackets on the studding.

Personally, not having the facilities, I would buy a case or pick one up
at a rally


Charlie.

--
Aspersions don't float.