adding WARC bands to an old Wilson SY2 tribander question
On Wednesday, June 6, 2012 at 1:25:59 AM UTC-5, VK3XL wrote:
After an interesting weekend working DX on 17 meters using a homebrew 5
band vertical antenna, I had a thought....... how much better would it
be to have a 2 or 3 element yagi on 17 and maybe 12 as well.
So here is the plan, either open sleeve feed the 17 and 12 meter driven
elements by close coupling it to the trapped driven element of my old
Wilson SY 2 tribander that is at 50 feet above the ground. Or build a
open sleeve fed 17/12 meter 2 el yagi and position it on the same boom
as the tribander and run a separate feeder to the 17 meter driven
element thus allowing greater separation of the new elements from the
original tribander elements.
I have looked around for generic trapped tribander models (MMANT-GAL)
but have found nothing. I am new to antenna modeling, but have read that
trapped triband yagis are difficult to model.
Is there any experience on the forum with this type of modification of
an existing tribander and if so what were the results like.
I have a fair stock of aluminium to make the new elements from, so the
project will cost me not much than the time I invest in it.
I am not interested in buying an all singing 5 band optibeam or StepIr
antenna, I would like to increase my performance on 17 and possibly 12
meters without degrading my performance on 20, 15 and 10 too much. I
also suffer from short arms and deep pocket syndrome.
Your thoughts (and sensible responses) are appreciated.
Mike VK3XL
--
VK3XL hi mike my names is carlos k5otd i like to know is you have the manual for the antenna wilson sy-2 im looking for the manual thanks 73 of k5otd
|