View Single Post
  #2   Report Post  
Old March 2nd 18, 07:48 PM posted to
Scott Dorsey Scott Dorsey is offline
external usenet poster
First recorded activity by RadioBanter: Jul 2006
Posts: 758
Default Heathkit SB-200 Help

In article ,
Edward Vignati wrote:
I have a SB-200, 75 watts in to the amp, the grid voltage, on dead key pegs the meter and the power slowly drops from 500 Watts to about 250 watts and the grid ma drops to about 200ma Grid, ma and watts both drop within 7 seconds.

But the meter light doesn't dim? If you set the meter to HV, is it also
dropping or does it stay nice and steady?

Are there any signs of weird oscillations? Does a scope with a probe
coupled near the output show a decent sine or an increasingly smeary mess?

The swr remains the same, I even changed the Balun thinking the toroid might be saturating until I saw the grid ma.

I have an extra pair of 572B tubes and tried them, same problem so I purchased and installed new 572B tubes, same problem.

So when I tune the amp for max power the grid ma is way out of specs.
Can anybody help with any suggestions? I checked the grid capacitors, their fine. I have no idea what to check next.

The tube is just a big capacitor from the standpoint of the grid drive
circuit. So if the grid is drawing a lot of current, either the grid bias
is in some wacky place (where it's no longer acting as a simple capacitor)
or else there is high frequency trash going into or coming out of it
since the capacitor has a low impedance at high frequencies). Which would
indicate oscillation.

Make sure, of course, that the transmitter driving it is putting out a nice
waveform to begin with. Check those little grid bypass caps. If the 33 ohm
resistors on the grid have been replaced, make sure they are still wirewound
ones and they are physically very close to the tube.

Check for a damaged bandswitch; that is a very very common failure on these
with a lot of weird symptoms.
"C'est un Nagra. C'est suisse, et tres, tres precis."