Home |
Search |
Today's Posts |
#11
![]() |
|||
|
|||
![]() Dave wrote: Mark wrote: modelman wrote: Several months ago I had a high efficiency Trane XV90 natural gas furnace and heat pump installed. Since the weather has recently been cold enough for the gas furnace to provide heat, I have been experiencing severe radio interference. The interference wipes out AM broadcast reception throughout my house. I also see snow on a TV connected to an external antenna. The radio noise occurs as soon as the draft inducer motor starts up; the pitch of the interference is related to the motor speed. The draft inducer motor is a dc motor driven by a PWM controller on the main circuit board. ... SNIPPED ... DC motors are notorious noise generators. Those of us who used to be mobile when 6 VDC was the value of a car battery, and alternators did not exist, will attest to the facts of generator [DC motor] noise. A DC motor uses brushes to contact windings within the motor. As the motor turns the brushes continually make and break current in the rotating armature [inductance]. This making and breaking creates a very wide HF and lower VHF noise spectrum. [Lots of sparks]. The solution, in the olden days, was a coaxial capacitor mounted directly to the frame of the motor with the DC power running through the capacitor. I recall the capacitor was about 1 inch in diameter and 2 inches long. Sprague made such a critter. Hope this history helps. /s/ DD, W1MCE I'm pretty sure these motors don't have brushes and are electronically commutated and the electronics are causing the EMI... Mark |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
FCC: Broadband Power Line Systems | Policy | |||
NTIA Claims BPL Could Help Alleviate Power Line Noise | Shortwave | |||
Amateur Radio Newsline(tm) Report 1394 - April 30, 2004 | Shortwave | |||
Amateur Radio Newsline(tm) Report 1394 - April 30, 2004 | CB | |||
IBOC interference complaint - advice? | Broadcasting |