![]() |
Rain Static ?
John Smith wrote:
Undoubtably, in a power failure, "most all" of the noise, both horiz and vert, goes away. How to you differentiate between what is the horiz component and that of the vert component? I continue to operate on backup power during an AC power failure. The change in noise level on my horizontal dipole is not very noticeable. The change in noise level on my vertical is 2+ S-units. It is obvious that the 60 Hz power lines furnish the source of the vertical noise with power. I am still not sure of the source of the vertical noise but I strongly suspect the ground wire on the pole in my front yard that contains a power factor capacitor. If I bring my portable AM radio close to that ground wire, I cannot even hear the local AM radio station. -- 73, Cecil http://www.w5dxp.com |
Rain Static ?
John Smith wrote: How better could the actual metal radiator (receiving element) be insulated from the physical striking of rain drops, other than in the nonconductive fiberglass casing it already resides in? What am I missing? It seems to me that static electicity, and hence noise, can be induced through the fibreglass. I used to have horrible wind static on a dipole made with insulated wire. I would suggest that the rain striking the insulated material could also induce a static charge. Irv VE6BP -------------------------------------- Visit my HomePage at http://members.shaw.ca/finkirv/index.html Visit my Baby Sofia website at http://members.shaw.ca/finkirv4/index.htm Visit my OLDTIMERS website at http://members.shaw.ca/finkirv5/index.htm -------------------- Irv Finkleman, Grampa/Ex-Navy/Old Fart/Ham Radio VE6BP Calgary, Alberta, Canada |
Rain Static ?
Cecil:
Yep. EXACTLY, the same problem here. I constructed a wideband fsm with a fet front end amping up the rf, then through a full wave rect and feeding two opamps in a lm324 acting as a VERY high gain dc amp, plug for ferite/"rubber duck"/telescope antennas. This finds the groundwire on a pole adjacent to my yard is a culprit, when brought close it pegs the meter and turns on the led (powered by extra opamps on board the lm324 acting as a comparator and voltage follower) in the output circuit. There is also a large, square, distribution xfmr where there are underground lines, although it appears perfectly shielded, it is yet another culprit on the opposite side of my property and gives a substantial reading on the same meter. Numerous complaints from me has had the power company send out individuals with an am radio, as you describe, they are quite taken with my "noise meter" when I show it to them, and the audio on their am radio confirms my meters reading--however, the noise is still there ... I am happy they like my meter! straight face Warmest regards, JS "Cecil Moore" wrote in message . .. John Smith wrote: Undoubtably, in a power failure, "most all" of the noise, both horiz and vert, goes away. How to you differentiate between what is the horiz component and that of the vert component? I continue to operate on backup power during an AC power failure. The change in noise level on my horizontal dipole is not very noticeable. The change in noise level on my vertical is 2+ S-units. It is obvious that the 60 Hz power lines furnish the source of the vertical noise with power. I am still not sure of the source of the vertical noise but I strongly suspect the ground wire on the pole in my front yard that contains a power factor capacitor. If I bring my portable AM radio close to that ground wire, I cannot even hear the local AM radio station. -- 73, Cecil http://www.w5dxp.com |
Rain Static ?
Cecil Moore wrote: art wrote: Cecil if a static charge has a time varying field applied by gravity would it have radiatiatonal properties and if so would it not be vertically polarised? Can't be true as it is not printed in a book ! Whoa there, Art. There seems to be confusion between two topics. As far as I know, there is no obvious difference between the precipitation static levels on a horizontal Vs vertical antenna. Cecil I am just putting up something for thought Apparently stacked antennas of the horizontal style can avoid a lot of static noise if they disconect the upper array. Could this possibly mean that the horizontal array will not pick up a vertically phased noise in the near region. I know nothing in this area but just offering something that could be discussed. That this particular antenna is vertical is mostly irrelevant to the alleged precipitation static problem. It could just as easily be happening with a horizontal antenna. The fact that the noise might be attributed to something other than precipitation static might involve vertical polarization but I don't think precipitation static has much to do with polarization. A wind-driven charged particle is just as likely to encounter a vertical wire as a horizontal wire. -- 73, Cecil http://www.w5dxp.com |
Rain Static ?
Cecil:
Netnews? News server? Newgroups? This ain't google chat? Huh? grin Regards, JS "Cecil Moore" wrote in message . .. John Smith wrote: How better could the actual metal radiator (receiving element) be insulated from the physical striking of rain drops, other than in the nonconductive fiberglass casing it already resides in? What am I missing? Netnews is a challenge. Apparently you have read his followup posting without reading mine. Just be patient. My followups will arrive on your server sooner or later. For instance, if he has uninsulated elevated radials, the same thing might be happening. Or maybe it's noise from lightning and not precipitation static at all. -- 73, Cecil http://www.w5dxp.com |
Rain Static ?
he OP mentioned that the static comes and goes with approaching and
receeding rain fronts... Likely he has a significant component of coronal discharge... He may PERHAPS reduce the induced noise a bit with ball on the top of the vertical, a copper float from the toilet works well, or even a nice capacity hat... NOw this is a topic that has been roundly beaten within an inch of it's life on other forums, but perhasps we are bored enough here to go all through it again groan denny / k8do |
Rain Static ?
Correct... Everything is known about antennas in America !
Denny wrote: he OP mentioned that the static comes and goes with approaching and receeding rain fronts... Likely he has a significant component of coronal discharge... He may PERHAPS reduce the induced noise a bit with ball on the top of the vertical, a copper float from the toilet works well, or even a nice capacity hat... NOw this is a topic that has been roundly beaten within an inch of it's life on other forums, but perhasps we are bored enough here to go all through it again groan denny / k8do |
Rain Static ?
This topic tends to be provocative. You have heard/read everyone's
opinions/measurements in the past. What is interesting in F5VJC's account is that the vertical is surrounded by what may be a good insulator. Additional information that will be of interest includes: 1. What is in the vicinity of the antenna? How far from exposed conductors, house, barn, trees, and such. Are objects within ten wavelengths higher than the antenna? 2. Are guy wires used to support the antenna? Some contend that P-noise exists and some contend that it does not exist associated with fixed antennas. F5VJC might be able to add a data point. 73 Mac N8TT -- J. Mc Laughlin; Michigan U.S.A. Home: "Denny" wrote in message ups.com... he OP mentioned that the static comes and goes with approaching and receeding rain fronts... Likely he has a significant component of coronal discharge... He may PERHAPS reduce the induced noise a bit with ball on the top of the vertical, a copper float from the toilet works well, or even a nice capacity hat... NOw this is a topic that has been roundly beaten within an inch of it's life on other forums, but perhasps we are bored enough here to go all through it again groan denny / k8do |
Rain Static ?
John, at 60 Hz a horizontal wire carrying current has a very strong magnetic
field. The 'right hand rule' indicates the magnetic field, a near field effect, is vertically polarized. My 60 meter horizontal is quiet. My 60 meter vertical, about 30 feet from the horizontal, has a good S4 noise level on the same radio at the same time. John Smith wrote: Dave wrote: ... Most all verticals have higher noise levels than horizontal antennas. Reason, as it is reported, is that man made noise is vertically polarized. Dave: Frankly, I think that the statement, "most man made noise is vertical polarized" is a myth. How many power lines do you see running vertically? How many extension cords do you see running vertically? How many phone lines do you see running vertically? Etc, etc. I think this needs looked at in a new light. Now most 160m antennas are easier to construct for horizontal operation--perhaps this is where the myth got started? Regards, JS |
Rain Static ?
Denny wrote:
he OP mentioned that the static comes and goes with approaching and receeding rain fronts... Likely he has a significant component of coronal discharge... He may PERHAPS reduce the induced noise a bit with ball on the top of the vertical, a copper float from the toilet works well, or even a nice capacity hat... NOw this is a topic that has been roundly beaten within an inch of it's life on other forums, but perhasps we are bored enough here to go all through it again groan The heated part of the discussion was because of the assertion that precipitation static does not exist. One only need do a web search for "precipitation static" to see that it is an accepted, well known, well defined physical phenomenon. -- 73, Cecil http://www.w5dxp.com |
All times are GMT +1. The time now is 04:40 PM. |
Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
RadioBanter.com