The patch I'm building uses an air dielectric so I'm using about .47 Lambda
on a side.
This site is my guide; http://www.rc-cam.com/gp_patch.htm
I'm feeding with coax thru the backplate with the center conductor to the
Patch. (probe feed)
Since the Patches are 0.47 Lambda, 1.0 Lambda spacing would leave 0.56
Lambda between Patches.
Probably to much. At 0.5 Lambda the patches would almost touch. Probably to
close.
So it's between 0.5 and 1.0 Lamda.
What criteria do I use to choose the spacing?

Are you concerned about grating lobes?
How much work do you want to go through to calculate or measure mutual
Z, so your feed network works?

Far apart reduces mutual coupling, so you can use a simple feed network
(i.e. power divider and equal length lines), but gives you grating lobes.

You have to calculate the pattern of your array (you could start with
the pattern of an array of isotropic elements, and then just multiply by
the pattern of one patch, which is typically some sort of cos(theta)^n
looking thing..

If far apart gives you an ok pattern, then go with it. It's easier,
although bulkier.




I looked at this page and it shows 0.2, 0.3, 0.4, and 0.5 Lambda
http://images.vertmarkets.com/CRLive...nArticle5a.pdf
Although for my antenna I think those numbers should be doubled, (0.4, 0.6,
0.8, and 1.0 Lambda.
What criteria do I use to choose the spacing?
Thanks, Mike