FWIW, I use 8lb monofiliament line and a 3oz fishing weight, and like
others, cast it over the tree with a fishing pole. Wristrockets can't
compare.

Also, in response to another poster, I have never had a fishing weight wrap
around a tree branch as long as it is allowed to fall to the earth. In
other words, allow the line to freely flow out until the weight has dropped
to the ground.

Russ
W6OHM





"R.Scott" wrote in message
...
I'm trying to restring my Dipole up in a Pine (the tree has grown
about 10 ft, and the rope needs replacing) so I got out my trusty
Surgical tubing wrist rocket and a 1oz egg weight tied to my 15# test
fishing rod/reel (only using the bottom eye).

No matter how far I pulled back I got about 2/3s of the way up. Im
estimating that is about the 35 ft level.


Shouldn't a wrister go farther ???? need bigger weight ?

Suggestions.

Well my Antenna Im trying to raise and replace the rope is STUCK.

It seems after all this time the tree has trapped the rope up there,
and the antenna is Too high for me to
reach the rope with my Tree Trimmer on a ladder (its 20ft long)

SOOO, how does one get the rope to break or what can i pull up with a
rope if I toss it over the old rope to cut the line

(Ive already pulled as hard as I dare, its STUCK)


Sheesh Simple antenna projects never seem to be simple

Scotty W7PSK

On May 19, 12:08*am, "R.Scott" wrote:
Well my Antenna Im trying to raise and replace the rope is STUCK.

It seems after all this time the tree has trapped the rope up there,
and the antenna is Too high for me to
reach the rope with my Tree Trimmer on a ladder (its 20ft long)

SOOO, how does one get the rope to break or what can i pull up with a
rope if I toss it over the old rope to cut the line

*(Ive already pulled as hard as I dare, its STUCK)

Climb up a ladder, cut it as high as you can.

The tree-trimmer-on-a-pole doohinkeys don't work well at all for
cutting ropes.

Next time use black ropes, they stand out a lot less than those
fluorescent orange ones!

Tim.

Tim Shoppa wrote:
On May 19, 12:08 am, "R.Scott" wrote:
Well my Antenna Im trying to raise and replace the rope is STUCK.

It seems after all this time the tree has trapped the rope up there,
and the antenna is Too high for me to
reach the rope with my Tree Trimmer on a ladder (its 20ft long)

SOOO, how does one get the rope to break or what can i pull up with a
rope if I toss it over the old rope to cut the line

(Ive already pulled as hard as I dare, its STUCK)

Climb up a ladder, cut it as high as you can.

The tree-trimmer-on-a-pole doohinkeys don't work well at all for
cutting ropes.

I cant get to the rope, I can reach about 1/3 of my antenna .. dont want
to leave that up there

I figure out something.

How do you get the rope down? How about attaching to the bumper of
your car and slowly driving away from the tree? Pad the 'edges' of
the bumper, they like to 'eat' rope. Hope the rope is weaker than the
tree.
Was on the receiving end of a piece of 30-40 foot nylon cord I was
trying to get off of a lamp post. You might be surprised at what that
stuff will feel like when it snaps and hits you. Took a few days, but
the welts finally disappeared. The memory will last forever!
- 'Doc

PS - Having a hardware store hanging from a tree is a sure sign of a
dedicated ham! Sort of a huge wind-chime, right?

On Wed, 21 May 2008 07:51:33 -0700 (PDT) in
rec.radio.amateur.antenna, wrote,
How do you get the rope down? How about attaching to the bumper of
your car and slowly driving away from the tree? Pad the 'edges' of
the bumper, they like to 'eat' rope. Hope the rope is weaker than the
tree.

Be sure to get it on video when you pull the tree down onto your car!

Well I finally got the rope cut, I Duct Taped my Tree trimmer
extended to 2 10 foot Rat Shack Mast pieces I had, that and getting
on the ladder a bit I was able to get up into the rope enough to cut
it.

Now the Good News is

I changed Reels in the wrist rocket, I was using Open Faced but
noticed all the ones on the net had a Zebco. So I grabbed a spare
zebco, walked out and zinngg right to the top of the tree, and then
it slid down slick as can be. Sent up the messenger string (small
nylon) and pulled the main cable back over and up went the antenna.
All is well now, I got frustrated cause the open faced would let it
spool out proper it was either short or hung up. Zebco worked peach.


Thanks for all the help folks

Scotty W7PSK.