Roy:

[snip]
Plots and tabular output of circular polarization components has been a
feature of EZNEC+ and EZNEC Pro programs since the introduction of v. 4.0
in May 2004. (The current version is 5.0.) This feature isn't included in
the demo or standard programs. I see it's not properly indexed in the
manual -- I've made a note to correct that at the next revision. It's
described in Getting Started/What Was New in v. 4.0.
[snip]

Oh, OK... as you likely know I am one of your customers, an EZNEC user, but
my version is older. :-(

There are no circular polarization outputs available in my version.

I'll purchase a new version so that I can have that capability.

Did you add the calculations to produce the circular outputs from NEC
rectilinear outputs yourself or is it/was it included in the basic NEC
codes?

Keep an eye out for my order. [smile]

Thanks!

-- Pete K1PO
-- Indialantic By-the-Sea, FL


"Roy Lewallen" wrote in message
...
Peter O. Brackett wrote:

Question for our own Roy Lewallen W7EL... Roy do you think that there
would be much of a market for EXNEC to provide circular polarization
outputs from EZNEC, and do you have any plans to implement output plots
from EZNEC in terms of circular polarization?

I can supply you with references to the needed transformations. Just a
few lines of Fortran or Visual Basic should do it...

Just asking? [smile]

Plots and tabular output of circular polarization components has been a
feature of EZNEC+ and EZNEC Pro programs since the introduction of v. 4.0
in May 2004. (The current version is 5.0.) This feature isn't included in
the demo or standard programs. I see it's not properly indexed in the
manual -- I've made a note to correct that at the next revision. It's
described in Getting Started/What Was New in v. 4.0.

Roy Lewallen, W7EL