Home |
Search |
Today's Posts |
#4
![]() |
|||
|
|||
![]()
Check from the coax connector to each side. I just did this with a Spi-Ro
160 I have been using. Center to the end of one side was a complete closed circuit. The other side shield to end was open. From the connector to the coil was closed but nada on the other side of the coil. So in my case the coil is bad. To start all you need to test is from the coax connector to each side just beyond the center connector/balun. W9INN used a 1 to 1 balun along with a connector. You can used a budwing center connector then add the balun (2 pieces). I would suspect the balun first then the center connector. If that antenna has traps check them also if everything is Ok in the center. Good luck. 73 Dave K4JRB "Dick" wrote in message ... I have an old W9INN (SK) 40/80 Dipole that has worked great; however, I suspect the balan or center feed may be open inside. I would like to know how to test it or how to obtain a replacement. Anyone know of a source of replacement parts for W9INN antennas? aa5vu |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
W9INN Dipole | Antenna | |||
W9INN 40/80 Dipole | Antenna | |||
W9INN antenna Help | Antenna | |||
HELP W9INN! sa-80 ant!!!!!!! | General | |||
w9inn SA-80 ANT???`S | Swap |