Home |
Search |
Today's Posts |
#6
|
|||
|
|||
Distance to Fault
On Nov 3, 6:22*am, ashwanthh
wrote: Hi all, For my project, I want to perform Distance to fault measurement in the cable connecting the antenna. The principle is that a signal should be sent to the cable and using the forward and reflected voltage VSWR should be calculated and should be viewed in a spectrum analyzer. My question is 1. *What transducer is used to detect the transmitted/reflected signals from the cable? 2. Should the transducer be connected in series or parallel? Anyone, Please help -- ashwanthh look up time domain reflectometers... they are much simpler than what you are thinking of. using a simple step input wave you measure the time to the reflection. if you get fancy you can measure the polarity and size of the reflection to determine if it is a short or open or impedance change... if you really get fancy you can hook a scope up and look at more details. the only transducer needed is a voltage probe OR a current shunt, either one will work depending on the installation needs. |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Bushes Fault | Shortwave | |||
Help with TS711 fault | General | |||
FT 480R fault - 147.000 MHz on TX | Homebrew | |||
RA17 Fault-Help Please | Shortwave | |||
RA17-FAULT, Help please | Boatanchors |