Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
Old July 23rd 11, 04:39 AM posted to rec.radio.amateur.antenna
external usenet poster
 
First recorded activity by RadioBanter: Dec 2006
Posts: 1,169
Default Cut length on antenna made from coax cable

"Sal" wrote in :

...
This thread got me thinking. If three or four tuned radials were
added, would this be a better approach?


A set of radials helps to decouple the feedline, in this case, you would
place them a quarter wave below the bottom of the sleeve.

Ok, you have noted commercial implemenations of this idea... yes it is
done. The quarter wave between the radials and the bottom of the sleeve
carries significant current, ie it affects the pattern and gain.

And still, decoupling is not perfect, though much better.

Whilst the OP's design looks like it is simple, in my experience it is
not. Whilst I have had a lot of success with coaxial dipoles where the
sleeve was three times or more the diameter of the inner element and
substantially air dielectric, I have had little success the the cheap
and nasty approach of applying braid over a vinyl jacket and trying to
adjust it for low common mode feed line impedance and low VSWR. I am not
saying it is impossible, just not as easy as a ground plane!

Owen
Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Building a Ready-Made "GreerTech" Coax Cable [Shielded] Loop Antenna with Multi-Heads RHF Shortwave 4 July 25th 07 03:29 AM
Cutting cable length to match 1/4 wave 162 MHz antenna? Robert Haston Antenna 6 July 25th 06 08:48 PM
TX to Antenna cable length? MRW Antenna 7 May 13th 06 02:55 AM
FS:RG8X 18 FT LENGTH COAX WITH COAX CONNECTOR Kb9igg Swap 0 October 31st 03 04:54 PM
TV antenna question-cable length Henry B. Antenna 2 July 22nd 03 03:10 AM


All times are GMT +1. The time now is 06:06 PM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 RadioBanter.
The comments are property of their posters.
 

About Us

"It's about Radio"

 

Copyright © 2017