Home |
Search |
Today's Posts |
#4
![]() |
|||
|
|||
![]()
The resulting SWR plot (using Zplot to display plots) looks good on 20m and
gives a better SWR plot than just tuning for best SWR. Also I am getting about 1dB better on field strength at about 30' from antenna. I suspect it will be more difficult on the lower bands. My transformer is not perfect but I am now getting 52 +j0 with it fitted. Using the 1/2 wave of coax results in errors below about 13.9 MHz and above 14.5MHz but otherwise matches the readings with the analyzer at the base of the antenna. Just for fun I made up a full 1/4 wave whip on 20m and tried it out this afternoon. Much better bandwidth and field strength but looked a bit ridiculous (and dangerous) on my little Fiat :-) Dick "Fred McKenzie" wrote in message ... In article , "Richard Ferryman" wrote: I have recently acquired an antenna analyzer and have been getting my mobile antenna ready for the summer (if we have one!). My procedure has been to attach the analyzer to the base of the antenna or via 1/2 wavelength of coax and tune the antenna to read j0 on complex impedance. This should then be correctly resonant. I then look at the real (resistive) part of the impedanceand use a transformer to match it. For example on 20M the antenna reads 35 + j0 so I have a transformer toroidal transformer from 50 ohms to 35 ohms. This seems to work well. Question is whether tuning for j0 is going to give a true resonance of the antenna? Any other suggestions? Dick- I think use of the 1/2 wavelength feed line, with you sitting inside the closed vehicle, should give you a true resonance reading. Or at least as close as you can get with the vehicle parked. My concern is that your matching procedure may be sensitive to frequency changes. In other words, whatever advantage you have at that one frequency, may be lost at other frequencies across the band. This might be especially true on 75 or 40 Meters. Does your analyzer show SWR? If so, compare a plot of SWR across the band between your method of matching vs just tuning the antenna for best SWR at the center of the band. Fred K4DII |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
antenna analyzer | Swap | |||
FA: Mobile Antenna Matching Unit | Swap | |||
Mobile Antenna Matching Question | Antenna | |||
FA: Coil Stock and Mobile Antenna Matching Unit | Swap | |||
Building a Matching Transformer for Shortwave Listener's Antenna using a Binocular Ferrite Core from a TV type Matching Transformer | Shortwave |