Home |
Search |
Today's Posts |
#4
![]() |
|||
|
|||
![]() "Jon Danniken" wrote in message ... On 03/20/2014 07:23 AM, Ralph Mowery wrote: Thanks Ralph, I guess that is exactly what is what I do not understand yet. I was just assuming that connecting the cone/shield to earth ground would change the characteristics of the cone into (what I had assumed would be) a ground plane. Extending this concept outside of discones, and applying it to a dipole, could you also directly feed a dipole, ground the shield, and still have it behave as a 1/2 wave dipole? Additionally, when does the need for a balun to transition between a balanced line and coax arise? Jon For the halfwave antenna I am going to assume that you mean one that is horizontal and up in the air some distance,then you use coax cable to come into the shack. You can connect the shield of the coax anywhere from right at the feed point (which would not be practical) to a point near the transceiver to the earth. A balun is mainly used to connect a ballanced antenna to an unballanced line like coax cable. The balun is a contraction of BALanced to UNbalance. They are not always needed, but may or may not help. A simple 1/2 wave dipole is a balanced antenna as each side is the same. Theory says to use a balun to keep the feed line from becomming a part of the antenna. I and many others have up dipoles that do not have baluns and they work fine. Baluns are often used on beam antennas so the radiation patern will not be distorted. Unless using an antenna tuner that has a built in balun or is designed for the open wire feedlines a balun is used to feed the coax connector of the transceiver. Most often it will be a 4:1 ratio to change the 300 to 600 ohm feedline to closer to 50 ohms to match the transceiver. A ground plane is unbalanced as the elements are not equal and so a balun would not do any good. Same as the discone you were asking about , no balun is needed as this is an unbalanced antenna. There is another thing that is often referred to as a choke balun, which is not actually a balun. It can be several turns of coax coiled up or a piece of coax with some of the ferrite beads over it. --- This email is free from viruses and malware because avast! Antivirus protection is active. http://www.avast.com |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Discone, etc. Questions | Antenna | |||
HF discone ????????????? | Antenna | |||
Discone antenna? | Scanner | |||
Antennas, 2.4 and discone | Swap | |||
Discone ant on 144/440? | Antenna |