Dhakala wrote:
I'm designing a thingie that requires 20 to 24 ga 300 ohm flat antenna
wire. I find it's a real PITA to separate the ends of the wire, trim
that 1/4" of insulation out from between them, and strip the ends. Is
there a tool that simplifies this job? If so, what is it called and
where might I find it?

Use 300 ohm ladder-line (window-line). Remove the inside dielectric
with an Exacto knife and treat the remaining wires normally.
--
73, Cecil http://www.qsl.net/w5dxp


----== Posted via Newsfeeds.Com - Unlimited-Uncensored-Secure Usenet News==----
http://www.newsfeeds.com The #1 Newsgroup Service in the World! 100,000 Newsgroups
---= East/West-Coast Server Farms - Total Privacy via Encryption =---