Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
Old December 19th 17, 07:57 AM posted to rec.radio.amateur.antenna
external usenet poster
 
First recorded activity by RadioBanter: Dec 2017
Posts: 4
Default NEC2 beginners question

Hi Dave,



On 13-12-17 00:26, Dave Platt wrote:
However, in the case of the slim-jim antenna, the feeder-cable is
connected on two different wires of the antenna.
So how do deal with this?


Add an additional wire (I believe 1 segment is adequate) between the
two points that you wish to drive with the incoming signal. Tell NEC
that this segment is where the source is connected.


Thanks for you reply.


It tried this. The radiation pattern seams to be more or less correct,
bt for some reason the SWR graph is all wrong (I have a SWR of 10 -whihc
is probably a "to high" on all frequencies).


I'll do some more research and come back to the NG if I cannot find the
sollution.



Anycase, thanks again for your help.



Kristoff - ON1ARF

Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
A Beginners Question Frank103 Shortwave 20 December 10th 07 07:13 PM
Quad loop supported by single tower - NEC2 modeling question [email protected] Antenna 3 December 8th 07 11:42 PM
question: NEC2 w/ ground parms. rjtucke Antenna 5 May 11th 06 02:39 PM
Website CB Beginners? (US) Henning Gajek CB 0 November 19th 04 11:57 AM
NEC2 modeling question Jack Twilley Antenna 8 April 10th 04 01:46 AM


All times are GMT +1. The time now is 07:03 PM.

Powered by vBulletin® Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Copyright 2004-2018 RadioBanter.
The comments are property of their posters.
 

About Us

"It's about Radio"

 

Copyright © 2017