Home |
Search |
Today's Posts |
#5
![]() |
|||
|
|||
![]()
In article ,
Roy Lewallen wrote: - You may not be able to clean it enough to re-establish a good contact - The copper may be gone from the portion of the rod which is beneath the soil surface, and hence your ground conductivity may be shot. Surely the ground conductivity doesn't depend on that thin plating of copper, does it? Isn't the conductivity of rust better than the dirt it's in contact with? The conductivity of the rod itself will certainly decrease by some amount, if when the copper is gone. I don't have a quantitative figure for this. Whether the rust (from the corroded steel) is more or less conductive than the soil surrounding it will probably depend to some extent on the soil conditions... but both will surely be less conductive than uncorroded metal (be it steel or copper). Every extra ohm in the current pathway is going to result in an increase in voltage rise across the grounding system if/when the system takes a hit. From what I see (based on a quick skim of the DoD-issued MIL-HDBK-419A on grounding and lightning protection), the copper plating serves two important purposes: compatibility with the copper wire, and protecting the steel of the rod from corrosion. By itself, it doesn't seem to be critical for carrying the current. If the copper's gone, and the steel is in direct contact with the soil, I'd be concerned about the rod suffering some fairly serious corrosion over a period of a few years. You might end up with a ground rod which was, in effect, only a foot or so long... it could break or be badly narrowed by corrosion not far below where it's hammered into the ground. This might seriously compromise its ability to shunt the charge of a lightning strike into the soil and keep the voltage rise on the attached wires to a level that minimizes damage. It probably depends a lot on the soil chemistry... e.g. acidic soils would probably be harder on an unplated ground rod that more alkaline soils, and would degrade it more rapidly. -- Dave Platt AE6EO Hosting the Jade Warrior home page: http://www.radagast.org/jade-warrior I do _not_ wish to receive unsolicited commercial email, and I will boycott any company which has the gall to send me such ads! |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
solid or stranded copper best ? | Antenna | |||
Copper antennas: | Antenna | |||
Shielding Question | Antenna | |||
APS 13 DX Antenna with a good 70s tuner | Antenna | |||
Poor quality low + High TV channels? How much dB in Preamp? | Antenna |