About Us

October 15th 03, 07:23 PM

Tarmo Tammaru wrote:
I measured the SWR at the point Cecil proposed. I don't recall him
specifying a transmission line either.

Everything was connected through three foot lengths of RG-400.
According to the guys over on sci.physics.electromag, that is a
long enough length to force a Z0 of 50 ohms upon the distributed
circuit. Is it easy for you to install some coax in your simulation?
--
73, Cecil http://www.qsl.net/w5dxp

-----= Posted via Newsfeeds.Com, Uncensored Usenet News =-----
http://www.newsfeeds.com - The #1 Newsgroup Service in the World!
-----== Over 100,000 Newsgroups - 19 Different Servers! =-----

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Re-Normalizing the Smith Chart (Changing the SWR into the	Richard Harrison	Antenna	58	September 3rd 03 04:49 AM
Re-Normalizing the Smith Chart (Changing the SWR into thesame...	Richard Harrison	Antenna	99	August 30th 03 06:26 PM
Re-Normalizing the Smith Chart (Changing the SWR into the same load)	Dr. Slick	Antenna	98	August 30th 03 03:09 AM
Re-Normalizing the Smith Chart (Changing the SWR intothesame...	Richard Harrison	Antenna	7	August 24th 03 01:45 AM
Length of Coax Affecting Incident Power to Meter?	Dr. Slick	Antenna	140	August 18th 03 08:17 PM

Menu

About Us