Yes, they exist. How's that?


"Eric" wrote in message
news:cgNib.757812$YN5.731961@sccrnsc01...
Any suggestions?

Thanks,

Eric

The message is titled 102" mobile antenna. It should ring a bell about being
a MOBILE. That should ring another bell that makes you think it's for a
vehicle.
Suggestions were expected from people who have had experience with these, or
can say something about these type of antenna.

Is it that hard to understand?

But ok, I'll explain a little further.
I'm installing a cb radio in my jeep, and I will be in very remote areas,
therefore I considered the full quarter length whip.

Any suggestions on what antenna to get?

Thank you,

Eric




"CW" wrote in message
news:bMOib.758913$YN5.732692@sccrnsc01...
Yes, they exist. How's that?


"Eric" wrote in message
news:cgNib.757812$YN5.731961@sccrnsc01...
Any suggestions?

Thanks,

Eric

I thought that was what you were after and sent this reply

Guess you are looking for a 102" CB whip antenna
Radio Shack used to carry the stainless steel ones

AND here is a fiberglass one by Shakespeare for $9.00
http://www.valcoelectronics.com/cbantenna/whips.htm
Scroll to bottom of page



--
73 From Keyboard
"Eric" wrote in message
. net...
The message is titled 102" mobile antenna. It should ring a bell about
being
a MOBILE. That should ring another bell that makes you think it's for a
vehicle.
Suggestions were expected from people who have had experience with these,
or
can say something about these type of antenna.

Is it that hard to understand?

But ok, I'll explain a little further.
I'm installing a cb radio in my jeep, and I will be in very remote areas,
therefore I considered the full quarter length whip.

Any suggestions on what antenna to get?

Thank you,

Eric




"CW" wrote in message
news:bMOib.758913$YN5.732692@sccrnsc01...
Yes, they exist. How's that?


"Eric" wrote in message
news:cgNib.757812$YN5.731961@sccrnsc01...
Any suggestions?

Thanks,

Eric

I'll probably go for the steel one. I'm trying to decide if a telescopic one
is a good idea or not.

Thanks

"KeyBoard In The Wilderness" wrote in message
news:n1Xib.64251$vj2.39772@fed1read06...
I thought that was what you were after and sent this reply

Guess you are looking for a 102" CB whip antenna
Radio Shack used to carry the stainless steel ones

AND here is a fiberglass one by Shakespeare for $9.00
http://www.valcoelectronics.com/cbantenna/whips.htm
Scroll to bottom of page



--
73 From Keyboard
"Eric" wrote in message
. net...
The message is titled 102" mobile antenna. It should ring a bell about
being
a MOBILE. That should ring another bell that makes you think it's for a
vehicle.
Suggestions were expected from people who have had experience with
these,
or
can say something about these type of antenna.

Is it that hard to understand?

But ok, I'll explain a little further.
I'm installing a cb radio in my jeep, and I will be in very remote
areas,
therefore I considered the full quarter length whip.

Any suggestions on what antenna to get?

Thank you,

Eric




"CW" wrote in message
news:bMOib.758913$YN5.732692@sccrnsc01...
Yes, they exist. How's that?


"Eric" wrote in message
news:cgNib.757812$YN5.731961@sccrnsc01...
Any suggestions?

Thanks,

Eric

Eric wrote:
I'll probably go for the steel one. I'm trying
to decide if a telescopic one is a good idea or not.

Telescopic is a very, very bad choice for anything
that bangs into tree branches or is exposed to
moisture, particularly salt water.

I had bad luck with fiberglass whips. The wire inside
was either too small for amateur-level (100W) transmitters
or had a splice or kink in it. I burned the wire in two
inside the fiberglass - black spot on the outside shell
and very intermittent operation.

I have had good luck with the garden-variety, stainless-
steel whips available from CB shops. If they get dinged-
up or bent, it's just a matter of a little pressure with
both hands and a knee to straighten them out. Besides,
the funkier they look, the more off-road you look. And
they can take kilowatts of power.

If you can't find stainless-steel whips locally, order
several (they're cheap here in Phoenix, about $18 each)
and have them UPS'ed over. That way you'll have spares.

Jim, K7JEB

I got a stainless steel 102" whip (one piece) at radio shack, for about $15.
Will see how it works...
Thanks for all the replies and sorry for the multiple replies from my part,
my provider was timing out and I tried a few times...

Later,

Eric

"K7JEB" wrote in message
news:9hYib.26262$Rd4.24491@fed1read07...

Eric wrote:
I'll probably go for the steel one. I'm trying
to decide if a telescopic one is a good idea or not.

Telescopic is a very, very bad choice for anything
that bangs into tree branches or is exposed to
moisture, particularly salt water.

I had bad luck with fiberglass whips. The wire inside
was either too small for amateur-level (100W) transmitters
or had a splice or kink in it. I burned the wire in two
inside the fiberglass - black spot on the outside shell
and very intermittent operation.

I have had good luck with the garden-variety, stainless-
steel whips available from CB shops. If they get dinged-
up or bent, it's just a matter of a little pressure with
both hands and a knee to straighten them out. Besides,
the funkier they look, the more off-road you look. And
they can take kilowatts of power.

If you can't find stainless-steel whips locally, order
several (they're cheap here in Phoenix, about $18 each)
and have them UPS'ed over. That way you'll have spares.

Jim, K7JEB

I'll probably go for the steel one. I'm trying to decide if a telescopic one
is a good idea or not.

Thanks

"KeyBoard In The Wilderness" wrote in message
news:n1Xib.64251$vj2.39772@fed1read06...
I thought that was what you were after and sent this reply

Guess you are looking for a 102" CB whip antenna
Radio Shack used to carry the stainless steel ones

AND here is a fiberglass one by Shakespeare for $9.00
http://www.valcoelectronics.com/cbantenna/whips.htm
Scroll to bottom of page



--
73 From Keyboard
"Eric" wrote in message
. net...
The message is titled 102" mobile antenna. It should ring a bell about
being
a MOBILE. That should ring another bell that makes you think it's for a
vehicle.
Suggestions were expected from people who have had experience with
these,
or
can say something about these type of antenna.

Is it that hard to understand?

But ok, I'll explain a little further.
I'm installing a cb radio in my jeep, and I will be in very remote
areas,
therefore I considered the full quarter length whip.

Any suggestions on what antenna to get?

Thank you,

Eric




"CW" wrote in message
news:bMOib.758913$YN5.732692@sccrnsc01...
Yes, they exist. How's that?


"Eric" wrote in message
news:cgNib.757812$YN5.731961@sccrnsc01...
Any suggestions?

Thanks,

Eric

I'll probably go for the steel one. I'm trying to decide if a telescopic one
is a good idea or not.

Thanks

"KeyBoard In The Wilderness" wrote in message
news:n1Xib.64251$vj2.39772@fed1read06...
I thought that was what you were after and sent this reply

Guess you are looking for a 102" CB whip antenna
Radio Shack used to carry the stainless steel ones

AND here is a fiberglass one by Shakespeare for $9.00
http://www.valcoelectronics.com/cbantenna/whips.htm
Scroll to bottom of page



--
73 From Keyboard
"Eric" wrote in message
. net...
The message is titled 102" mobile antenna. It should ring a bell about
being
a MOBILE. That should ring another bell that makes you think it's for a
vehicle.
Suggestions were expected from people who have had experience with
these,
or
can say something about these type of antenna.

Is it that hard to understand?

But ok, I'll explain a little further.
I'm installing a cb radio in my jeep, and I will be in very remote
areas,
therefore I considered the full quarter length whip.

Any suggestions on what antenna to get?

Thank you,

Eric




"CW" wrote in message
news:bMOib.758913$YN5.732692@sccrnsc01...
Yes, they exist. How's that?


"Eric" wrote in message
news:cgNib.757812$YN5.731961@sccrnsc01...
Any suggestions?

Thanks,

Eric

What is very clear is that you would fill a hole in my kill file. Bye.


"Eric" wrote in message
. net...
The message is titled 102" mobile antenna. It should ring a bell about
being
a MOBILE. That should ring another bell that makes you think it's for a
vehicle.
Suggestions were expected from people who have had experience with these,
or
can say something about these type of antenna.

Is it that hard to understand?

But ok, I'll explain a little further.
I'm installing a cb radio in my jeep, and I will be in very remote areas,
therefore I considered the full quarter length whip.

Any suggestions on what antenna to get?

But ok, I'll explain a little further.
I'm installing a cb radio in my jeep, and I will be in very remote areas,
therefore I considered the full quarter length whip.

Your initial question was pretty vague..

The steel whip is pretty robust.
I used to run one, with the spring removed so it was resonant on the ham 10
meter band.
Good results worldwide with 25W on sideband.

As I said, watch the short overhangs!
Otherwise, there isn't much to break on them, and no protruding coils to
hang in the brush.

Now, I run a cobra 6000 centerload, and a Diamond SG7900.
A 102" whip isn't practical, on a roof mount. At least not when your roof is
7' off the pavement.
The cobra is mag mounted, so it fails soft, but still, the fall isn't good
for it, or the car.
The 7900 dosen't bend, it breaks. If it didn't have such great gain, I
wouldn't put up with it.

http://www.inchase.org/outflow/event...2/f5Mount.html
This is the 7900 mount.
I had a bit of a surprise with floopyness of the roof metal, but that was
easily solved, once we found the right bit at the hardware store.

The problem with antennas, is that you can't get high gain, omnidirectional,
and reasonable bandwidth, without also picking "large".

Keep the antenna as clear of the vehicle as possible, and make sure that
what it's mounted to, is really grounded. Bumpers sometimes aren't these
days, and few want to dig the hole in the side panel for the old ball mount.
(Side panels aren't what they used to be either!)