"wb0gaz" wrote in message
ps.com...
Preparing to install a Diamond VHF/UHF base vertical X6000A, and
planning to paint it beforehand to a less visible color (here, dark
green will be better than white).

Is there any issue with this (affecting RF performance)? Does the outer
(fiberglass? plastic?) white jacket have any dielectric characteristic
necessary for antenna operation that would be affected by paint? Any
type of paint to avoid (I was planning Rust-Oleum textured dark green.)

Here is one recommendation:

Antenna Painting Instructions

The following is courtesy Celwave This is what I received when I asked
them for a recommendation of what to use in refinishing my 18 year old
PD455

Celwave receives requests for advice about refinishing weathered antenna
radomes or changing the radome color for aesthetic
reasons. We do not take a position on any manufacturer's paint. However,
Sherwin-Williams seems to make a product, which
should be compatible with radomes and not interfere with the antenna's
electrical performance. The following suggestions are
not a substitute for detailed instructions and mix ratios provided by the
paint manufacturer.



RADOME MATERIAL (Standard Color)
CELWAVE PRODUCT LINE
1. Spun Epoxy Fiberglass (Blue)
Penetrator Antennas (AxR, BxR
Series)
2. Polyester Impregnated Fiberglass (White)
Stationmaster Antennas (PDxx Omni
Series.)
3. Polyester Impregnated Fiberglass (Grey)
FR CELlite Panel Antennas (AP18, 19
Series)
4. ASA (Grey)
FR CELlite Panel Antennas (AP90
Series)
5. AES/ABS (White or Grey)
US Panel Antennas (Other APxx
Models)
6. Gel Coated Fiberglass Tubing (White)
Marine Antennas (Cel-1, 3 etc.)


Notes:

FOR RADOME
MATERIAL
USE THIS FINISH
#1, #2, #3
Primer and Top Coat
#4, #5
Primer may be required ----

(Top Coat retention may be tested with adhesive tape after
paint dries)
#6
Requires Pre-Treat (Acid Etch) to remove gloss, then Primer
and Top Coat




SHERWIN-WILLIAMS PRODUCTS:

Etch
P60G2 "Wash Primer"
Primer
D61H75 "Polane 2.8 Plus Spray Fil"
Top Coat
Polane Type "HS 2.8 Plus Polyurethane"




SURFACE PREPARATION:

Removal of surface contamination is normally accomplished by using an
alcohol solvent, ethanol, propanol, isopropanol, or
butanol. A ten percent solution of methyl ethyl ketone in water can also be
used whenever stubborn oil or grease is
encountered.



APPLICATION PROCEDURES:

Painting to be done indoors, as the uncured product is sensitive to
moisture. Apply one coat of Polane 2.8 Plus Spray Fil
D61H75 Primer. It is designed to fill and/or hide profile and surface
imperfections on metal castings, structural foam, plastic and
wood. Apply one coat of Polane HS 2.8 Plus Polyurethane Enamel Monochromatic
Intermix Color System F63 Series.



FOR FURTHER S-W PRODUCT INFORMATION CONTACT:

Ralph Stadalman - Product Finishing Representative
The Sherwin-Williams Company
Chemical Coating Facility
3165 Tucker Road Bensalem, PA 19020
Voice = (215) 638-0104
Fax = (215) 638-1008



Rev: #5 10/05/98 DLS

File: PAINT.doc