Thanks to all who replied. I think I'll just stick with the Silver-plated
Amphenol 83-1SP. The phenolic has never melted on me and the Silver-plated
body has always soldered up FB. Tnx agn es...

--
Vy 73 de Bert
WA2SI
FISTS #9384
QRP ARCI #11782
"Jimmie" wrote in message
. com...

"John Passaneau" wrote in message
...
It will not happen anyway. That is not a real problem. The real problem
is
most of the gold/Teflon PL259's I've seen are not very good connectors.
One
batch I had was giving me trouble soldering the braid. So I measured the
inside diameter of the area where the 4 holes you solder the braid
through.
It was 0.050" bigger in diameter than the good amphonal connectors I
normally use. It made it hard to solder trying to fill that big of a gap.
I ve had various problems with Gold connectors too. On the last batch the
insulators kept pulling out.There may be some good ones out there but I am
begining to think the gold /Silver is just window dressing for inferior
products.
.

Hi All
If you get the connector hot enough to damage the phenolic in the Amphenol
connectors, the coax was all ready melted and dripping out the back. Heat
resistance is a non issue.


--
John Passaneau, W3JXP
Penn State University




"Bert Craig" wrote in message
...
Thanks to all who replied. I think I'll just stick with the Silver-plated
Amphenol 83-1SP. The phenolic has never melted on me and the Silver-plated
body has always soldered up FB. Tnx agn es...

--
Vy 73 de Bert
WA2SI
FISTS #9384
QRP ARCI #11782