On 23 Feb 2005 09:53:05 -0800, "Dave" wrote:

Done and done... nice program! I'm hoping I entered the correct values
for everything. Do the patterns listed below look correct?

Hi Dave,

Yes, however, you will notice there is still a cone of silence above
any of these even if the preferred angle is now higher towards a
balloon.

I assumed
things like wire diameter (I used 2mm) didn't affect the output
significantly... although I did notice some things like the number of
segments did affect the output if I decreased them (I used 10 for these
cases).

Not so much that any change will fill in the cone.


73's
Richard Clark, KB7QHC