Home |
Search |
Today's Posts |
#11
|
|||
|
|||
Richard:
If I use that at QRP levels, then go to QRO, that constant current source will be used! I have a couple of burnt leds which offer proof... at a KW the fet would wave bye-bye (even before I suspect)... Regards, John "Richard Clark" wrote in message ... | On Wed, 4 May 2005 16:13:10 -0700, "John Smith" | wrote: | | And, that current source works, I have used it many times (makes an | excellent test lamp for 5-30V)... will with stand at least 30V+ across drain | and source and maintain ~10ma... when the REV current to its' led drops to | zero, max flows though the FWD--all other cases they must share that 10ma... | | Hi Brett, | | I've no doubt, but in your circuits - never. Doesn't make sense | unless you need parts ballast. It's like when the watchmakers | advertised watches with 60 jewels, and there were only half a dozen | points that actually used them. | | 73's | Richard Clark, KB7QHC |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
FS: MFJ 941D Antenna Tuner + MFJ 204B Antenna Bridge + MFJ 202B Noise Bridge | Shortwave | |||
FS: MFJ 941D Antenna Tuner + MFJ 204B Antenna Bridge + MFJ 202B Noise Bridge | Swap | |||
Bridge Megger Tester. Series 2. 500 Volt. | Boatanchors | |||
FS: E.F. Johnson Phone Patch and SWR Bridge, Gonset CPO | Equipment | |||
FS Tennatest RF Noise Bridge 1-150 MHz | Swap |