| Home |
| Search |
| Today's Posts |
|
#11
January 7th 06, 05:25 PM
posted to rec.radio.amateur.antenna,rec.radio.amateur.misc,sci.electronics.design
|
|||
|
|||
Need some pointers on building UHF/microwave 50 ohm termination/power splitter
On Sat, 07 Jan 2006 16:49:52 +0100, Paul Burridge
k wrote: On Fri, 06 Jan 2006 19:40:27 -0700, Wes Stewart wrote: http://cgi.ebay.com/HP-909A-50-Ohm-C...QQcmdZViewItem Thanks, Wes. I'll keep an eye on it. Secondly, a 50 ohm power splitter (one feed-in; three outputs) N-type connections, again flat up to 1.3Ghz. No switching needed, thankfully. I must ask, what is the purpose of this? The (thumping great) service manual that came with this VNA gives various levels of tests that can be performed oneself prior sending the thing away for calibration. The power splitter together with a few other basic items enables the analyzer to 'check itself' for fundamental operating fitness. Okay, I couldn't figure out what operational use it would have. |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| CATV splitter question | Antenna | |||
| Reducing effects of RF noise? | Shortwave | |||
| CATV splitter question | Antenna | |||
Threaded Mode
