| Home |
| Search |
| Today's Posts |
|
|
|
#1
July 25th 06, 09:48 PM
posted to rec.radio.amateur.antenna
|
|||
|
|||
Cutting cable length to match 1/4 wave 162 MHz antenna?
On Tue, 25 Jul 2006 11:12:44 -0700, Bill Turner
wrote: ORIGINAL MESSAGE: On Tue, 25 Jul 2006 15:38:04 +0200, Helmut Wabnig *_.-_- wrote: Side note: Did you note I left out the receiver? Does anybody know the input impedance of his receivers in use? How would you measure the input impedance? ------------ REPLY SEPARATOR ------------ I would think a MFJ SWR analyzer would do it. Haven't tried it, but can't think of a reason why it wouldn't work. Hi Bill, Good suggestion. 73's Richard Clark, KB7QHC |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| How High will my Shortwave Listener (SWL) Quarter Wave Length (1/4 WL) Vertical Antenna Need To Be ? | Shortwave | |||
| Grounding | Shortwave | |||
| The "TRICK" to TV 'type' Coax Cable [Shielded] SWL Loop Antennas {RHF} | Antenna | |||
| The "TRICK" to TV 'type' Coax Cable [Shielded] SWL Loop Antennas {RHF} | Shortwave | |||
| significance of feedline orientation | Shortwave | |||
Hybrid Mode
