| Home |
| Search |
| Today's Posts |
|
#1
September 3rd 03, 12:15 PM
|
|||
|
|||
Adapter needed
I need a "Western Electric to BNC" adapter for a signal generator I just
acquired. If anyone has one around that they would like to part with, or info on who sells them I would appreciate it. Thanks Bob |
|
#2
September 3rd 03, 02:16 PM
|
|||
|
|||
|
Must have an HP3336.
The actual adapter is very expensive, but if you can find some jumper cables, you can easily make one. A BNC chassis mount jack will screw right into the end of the WE connector. Note, Trompeter makes a connector that *looks* to be identical, but it isn't! It has a smaller center pin. -Chuck Bob Fay wrote: I need a "Western Electric to BNC" adapter for a signal generator I just acquired. If anyone has one around that they would like to part with, or info on who sells them I would appreciate it. Thanks Bob |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| FS: sma-to-bnc custom fit rubber covered antenna adapter | Antenna | |||
| Sucoflex and wireless adapter | Antenna | |||
| HELP! NCG 10/160M Manual needed A.K.A. National RJX-810D | Boatanchors | |||
| Manual Needed for NCG 10/160M AKA National (Panasonic) RJX-810D | Boatanchors | |||
Linear Mode
