Jeff
That would be very nice. I've downloaded from BAMA the TO-6 and TO-6A and
the difference I see is that Sprague added two resistors R37 and R38 and
changed the value of two R18, and R33. What I'm interested in is the value
of R16, there's two, what are their values in your TO-6? No pix necessary
unless you want to.
73
Hank wd5jfr
"Jeffrey D Angus" wrote in message
...
Well for what it's worth, I have a TO-6 in the shop, that's not too
far underneath everything else. I can probably take some pictures of
the innards.

Jeff


Henry Kolesnik wrote:
I understand not wanting to open the TO-6 but if I begged would you
change
your mind. After just about giving up I was able to get the TO-6 and
TO-6A
from BAMA and the "Bottom view of chassis" on page 14 is the same as my
manual,. two R16 and I need to know the value since both of mine are
different and I think both have been replaced with incorrect values.
tnx
73
hank wd5jfr

--
"They that can give up essential liberty to obtain a little temporary
safety deserve neither liberty nor safety." Benjamin Franklin
"A life lived in fear is a life half lived."
Tara Morice as Fran, from the movie "Strictly Ballroom"

Hi,
Well what I'm hinting at, is that I think mine didn't match the
schematic either, and I recall whoever I was discussing the problem
with (perhaps on the newsgroup or Forum) had a TO-6 that didn't match
as well. I recall extra resistors tacked in there in parallel or
something equally hokey. But that's the way it came from the factory,
as it's highly unlikely that *everybody's* TO-6 has been hacked up by
former owners.

73, Alan

The paralleled resistors make sense, at least to me, I have no problem
understanding that part. What I think might be the case is that there are
some undocumented variations between the TO-6 and TO-6A. My main problem is
what is the value of the lower R16 resistor in the picture that shows the
underside of the chassis.
73
hank wd5jfr
"Alan Douglas" adouglasatgis.net wrote in message
...
Hi,
Well what I'm hinting at, is that I think mine didn't match the
schematic either, and I recall whoever I was discussing the problem
with (perhaps on the newsgroup or Forum) had a TO-6 that didn't match
as well. I recall extra resistors tacked in there in parallel or
something equally hokey. But that's the way it came from the factory,
as it's highly unlikely that *everybody's* TO-6 has been hacked up by
former owners.

73, Alan