Consumer impedance is HI Z (10-20K) not 8 ohms...
Only SPKR out is 8 ohms......two caps in series will not match low to medium
Z....only a xfmr will do that....

For consumer line to PRO connection, you can do this:
tie consumer ground to Pro shield.....
tie consumer high to either PRO + or - input...
leave remaining input floating....do NOT ground or tie to other input (this
will be close and give you a good enough range to work with)..

Chris
(WB5ITT)

"WShoots1" wrote in message
...
Allegedly two 470 mfd caps in series will match 8 ohms to 600 ohms.

Shack has an 8 ohm to 1000 ohm c.t. transformer that could work, too. Just
pick
off half the 1000 ohm side.

Bill, K5BY
SE Texas