LinkBack Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #3   Report Post  
Old February 25th 04, 07:59 PM
Dr. Death
 
Posts: n/a
Default


"Frank Gilliland" wrote in message
...
In , jim wrote:

I have been using Belden 9913 RG-8U solid core for the past 7 years.
Its used with a Jogunn 5+5 beam and Yaesu rotor. Will this stand up for
another 10+ years or ditch it for some low loss, stranded, foam or
non-contaminating coax?



Used coax can be tested on the bench for characteristic impedance,

dielectric
integrity, DC resistance, and even for pinholes in the outer insulation.

But
unless you measured these factors when new, you can't make a good

determination
of its quality after several years of use. The problem is that your

average coax
isn't hermetically sealed, so moisture will eventually seep in and slowly
corrode the conductors. Weaknesses in the outer insulation (due to age,

oil
contamination, mechanical stresses and manufacturing imperfections) cause
microscopic pinholes that make the corrosion process go faster. It's best

to
replace your coax periodically. I would say that seven years is plenty

long
enough for an outside line.

Now I can't stress this enough: -=DON'T USE FOAM=-!!! There are several

reasons
not to use foam. First, foam coax is very porous and is intended for

controlled
environments where there is little variation in temperature and humidity,

the
factors primarily responsible for moisture seeping into the coax. Second,

the
dielectric softens with just mild heat, and the line could be ruined by

nothing
more than a hot sunny day. Also, the foam doesn't have the mechanical

strength
to handle the stresses of being clamped to an antenna and hung from any

decent
height, not to mention the repeated movements caused by wind, or the

expansion
and contraction caused by wide temperature changes. For antenna

installations,
foam coax is -BAD NEWS-!

As far as solid vs. stranded is concerned, the only real advantage of

solid is a
higher usable frequency (we're talking GHz here). Stranded conductors

offer more
flexibility, which is important when the coax is constantly under the

mechanical
stresses of an antenna installation.

The only other thing you may want to know about any type of coax is how

flexible
it will be when the weather turns cold. In that respect, I have yet to

find any
coax that fills the bill.







-----= Posted via Newsfeeds.Com, Uncensored Usenet News =-----
http://www.newsfeeds.com - The #1 Newsgroup Service in the World!
-----== Over 100,000 Newsgroups - 19 Different Servers! =-----


Excellent answer! My only addition is (and correct me if I'm wrong)
electrons follow the surface of the wire and stranded wire offers more
surface area than solid wire.

--
visit http://www.geocities.com/linearschematics/


 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
The "TRICK" to TV 'type' Coax Cable [Shielded] SWL Loop Antennas {RHF} RHF Antenna 27 November 3rd 04 01:38 PM
Coax antenna for aircraft, help. Carl J. Hixon Antenna 9 November 1st 04 04:59 PM
Dead Serious T2FD: HV Insulation, EMP Arrestors, extra Coax Choke? SpamHog Antenna 20 August 21st 04 05:05 PM
Coax choke, losses and ferrite Crazy George Antenna 0 April 4th 04 01:50 PM
Poor quality low + High TV channels? How much dB in Preamp? lbbs Antenna 16 December 13th 03 03:01 PM


All times are GMT +1. The time now is 09:31 AM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 RadioBanter.
The comments are property of their posters.
 

About Us

"It's about Radio"

 

Copyright © 2017