| Home |
| Search |
| Today's Posts |
|
#8
April 10th 04, 04:13 PM
|
|||
|
|||
"Dr. Death" wrote in message
... "Bill Seas" wrote in message ink.net... Ain't this a kicker. I bought a Uniden PC 68 LTW Peaked & Tuned, (6w swings to 18.) Had an old Cobra repaired, tweaked & tuned (6w swings to 18) I'm using a Wilson 1000 through the trunk mount on this Civic with resistor plugs & wires. The Uniden even with the NB on still gives me too much ignition noise for me to use, the old dog Cobra is quiet as a mouse. Wonder why that is? Could be the way the uniden was peaked, maybe clipped the wrong diode. If the noise were in both units I would say its in the truck, but you say the cobra works fine. Try having a tech look at the uniden to make sure the unit itself is not the problem. Will do thanks for the reply. |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Noise Figure Measurements | Homebrew | |||
| Low band noise (a possible "hot pole" nearby) | General | |||
| signal to noise ratio drops on connecting the antenna | Homebrew | |||
| signal to noise ratio drops on connecting the antenna | Homebrew | |||
| Automatic RF noise cancellation and audio noise measurement | Homebrew | |||
Threaded Mode
