| Home |
| Search |
| Today's Posts |
|
#1
October 13th 06, 02:59 AM
posted to rec.radio.amateur.digital.misc
|
|||
|
|||
setting up rigblaster
OK I can get my blaster to TX or RX but not both. If I set the VOX
high it goes to TX. If low it stays on RX. If intermediate it oscillates. Any answers? |
|
#2
October 13th 06, 07:02 AM
posted to rec.radio.amateur.digital.misc
|
|||
|
|||
|
setting up rigblaster
Rig?
-- Alan WA4SCA |
|
#3
October 13th 06, 11:15 AM
posted to rec.radio.amateur.digital.misc
|
|||
|
|||
|
setting up rigblaster
"wf3h" wrote in message ups.com... OK I can get my blaster to TX or RX but not both. If I set the VOX high it goes to TX. If low it stays on RX. If intermediate it oscillates. Any answers? Could it be RF feedback through the mike cable? That is what happened to me. Ed, N5EI |
|
#4
October 13th 06, 11:58 PM
posted to rec.radio.amateur.digital.misc
|
|||
|
|||
|
setting up rigblaster
Alan WA4SCA wrote: Rig? -- Alan WA4SCA Hi Alan Using 756 proII and old Pentium computer with sound card |
|
#5
October 13th 06, 11:59 PM
posted to rec.radio.amateur.digital.misc
|
|||
|
|||
|
setting up rigblaster
Edward Feustel wrote: "wf3h" wrote in message ups.com... OK I can get my blaster to TX or RX but not both. If I set the VOX high it goes to TX. If low it stays on RX. If intermediate it oscillates. Any answers? Could it be RF feedback through the mike cable? That is what happened to me. Ed, N5EI You know it DOES sound like feedback, but it happens even with the mike disconnected...go figure! |
|
#6
October 15th 06, 11:53 PM
posted to rec.radio.amateur.digital.misc
|
|||
|
|||
|
setting up rigblaster
wf3h wrote: OK I can get my blaster to TX or RX but not both. If I set the VOX high it goes to TX. If low it stays on RX. If intermediate it oscillates. Any answers? got it...line balance control needed to be muted. once that was done everything worked fine thanks everyone |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Announcing a new Rigblaster discussion group.. | Digital | |||
| Setting up slitting saw for round stock? | Antenna | |||
| SETTING UP AN OPTIMOD AM | Broadcasting | |||
| Rigblaster & USB follow up | Digital | |||
| WTB: RigBlaster with a 4 pin mic connector | Swap | |||
Linear Mode
