Home |
Search |
Today's Posts |
#1
|
|||
|
|||
HP8551B Contol Cable
I have an HP 8551B / 851B spectrum analyzer. It's missing the control cable that connects the display section to the Rf section. I found the connectors needed to make the cable but can't find the schematic to the cable.
So I'm wondering if anyone can confirm if this cable is wired pin to pin. For example pin 1 on one connector is electrically connected to pin 1 on the other end etc.. all the way to pin 14? Or do any pins cross over to another number? I would appreciate any help. Thanks. Don |
#2
|
|||
|
|||
HP8551B Contol Cable
"donavg" wrote in message ... I have an HP 8551B / 851B spectrum analyzer. It's missing the control cable that connects the display section to the Rf section. I found the connectors needed to make the cable but can't find the schematic to the cable. So I'm wondering if anyone can confirm if this cable is wired pin to pin. For example pin 1 on one connector is electrically connected to pin 1 on the other end etc.. all the way to pin 14? Or do any pins cross over to another number? I would appreciate any help. Thanks. I don't know how much this will help, but I have the manual for the 852A display section, which was also used on the 8551. It shows pins 1 to 10 are control lines from the 8551 (-24V), pin 11 as -24V, pin 12 as -15V, pin 13 as +15V and pin 14 as ground. Didn't see anything about the cable itself, but it's supposed to come with the RF section. HTH, -NM |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Cable Killer? Kenwood KPG-22 cable failures- they work then die! Why? | Swap | |||
FA: Alliance HD-73 Rotor Contol Box | Swap | |||
Need Power Cable For Kenwood Eq KGC-6042 or 4042 (Same Cable For All Of them) | Equipment | |||
Help HP8551B spec please? | Equipment | |||
Help HP8551B spec please? | Equipment |